Cabling for Remote Connectivity (Post-Initial Setup)

Once you have installed and configured your operating system and third-party application, you can connect remotely to the OSN server through your network, using protocols such as remote desktop (RDP) or Telnet (SSH). The connection to the OSN server is through the Ethernet port(s) on the OSN4 module.

➢ To connect to the LAN interface:
1. Connect an RJ-45 connector, on one end of a CAT 5 (5e or 6) cable, to one of the Gigabit Ethernet ports on the OSN4 module. For connector pinouts, see Error! Reference source not found..
2. Connect the other end of the cable to your network.

Cabling OSN4 Module to Network

The RJ-45 connector pinouts for the Gigabit Ethernet interface are listed in the following table:

RJ-45 Connector Pinouts for Gigabit Ethernet Interface on OSN4 Module

Pin

 

100Base-Tx

1000Base-T

I/O

Signal

Signal

Function

1

0

Tx+

I/O

BI_DA+

2

0

Tx-

I/O

BI_DA-

3

I

Rx+

I/O

BI_DB+

4

-

-

I/O

BI_DC+

5

-

-

I/O

BI_DC-

6

I

Rx-

I/O

BI_DB-

7

-

-

I/O

BI_DD+

8

-

-

I/O

BI_DD-